ET151020 Outdoor Telecom Cabinet
The Outdoor Telecom Cabinet is widely used in wireless
communication base station, such as 3G system,
communication/network integrated service, access/transmission
switching station, emergency communication/transmission, etc.
The cabinet is made of 1.5mm hot dip galvanized steel, and consists
of outer cabinet body and inner accessories. The cabinet includes
two equipment compartments. It is easy for installation and with
perfect sealing performance.
Door and Door Lock: The cabinet door uses embedded structure. The
door opening angle is larger than 110° and the door limit device
can limit the opening angle. The lock is theftproof three point
lock. There’s open door alarm sensor, which works together with the
environment monitoring unit.
Cabinet Size : 1500mm×1000mm×2000mm (W×D×H)
3.1 The cabinet is dustproof, sunproof and rainproof, which is
suitable for outdoor environment.
3.2 -48V LED lamps is installed inside the cabinet.
3.3 The layout of the cabinet is reasonable, which will facilitate
cable access, fixing and grounding. There’re entrance holes
individually for power cable, signal cable and optical cable.
3.4 All the cables used in the cabinet are made from flame
4.1 Applicable environment conditions:
Environment temperature: -40°C ~ + 60°C
Environment humidity (RH): ≤95% (at + 40°C)
Air pressure: 70kPa ~ 106kPa
4.2 Material: hot dip galvanized steel
4.3 Surface treatment: degreasing, derusting, rustproof phosphating
(or galvanizing), powder coated.
4.4 Cabinet load bearing: ≥600kg
4.5 Ingress Protection: IP55
4.6 Flame retardance: comply with GB5169.7 test A
4.7 Insulation resistance: the insulation resistance between
grounding devices and cabinet
body parts is not lower than 2X104M/500V(DC).
4.8 Withstand voltage: the withstand voltage between grounding
devices and cabinet body
parts is not lower than 3000V(DC)/1min.
4.9 Mechanical strength: each surface can bear upright
pressure＞980N; after the door is
open, its outer end can bear upright pressure ＞200N.
Cabinet, 1 set;
2U environment monitoring unit (8DI, 6DO, 6AI), 1 set;
Sensors: 1 smoke sensor, 2 door alarms, 2 LED lamps, 1 water
sensor, and 2 temperature and humidity sensor;
PDU, 1 set;
Fans, 4 sets.
See the Annex 1 “Monitoring Unit SM2200 Manual”.